![]() I found this Hardly noticable, and found only after a hint in the internet after 16 hours of searching.Īfter that choose your ECU as stated in the List that opens after you choose GENERIC Navigate to where you choose brand and choose not VW or Audi etc.And before connecting the negative wire be sure to ground the bootmode pin 24 thru a 5k resistor, and remove it after aprox 15 seconds, but do not disconnect the ecu and MPPS power connections. Before connectin the +12v power supply to the proper cable as you have seen in the pictures above. This was tricky for me, but finally i got to this point and after that everything was a peace of cake. When all done and checked twice, connect your MPPS cable to PC, open software and locate the BOOTMODE wirte function.MPPS Cable Pinout: (it’s mpps v12, but out of date now is mpps v18) Prepare all the connections to the ecu and MPPS cable as shown on the picture below.Here are the picture of the chip, and the pin to be used. To the other end of the wire connect 5k resistor. For now you have to solder a wire to the pin. Here is the picture, this is what you will probably see inside the ECU case. Dont heat it too much, just to be hand warm. Warm it a little bit up, there is a sealnt which holds the housing halves pretty strong, so after warming will be easier to open it. Note: You do this on your own, and i cant be responsible for mistakes you make! So here it is in very short description, with pictures. I found this very hard to do, and while searching decided that if i succeed to recover i will do a simple instructions how to do it without asking too many dumb questions. Everyone was saying that is “simple, just write in bootmode”, “MPPS can recover almost any EDC15 ECU”, “I’ve done many times” an so on. I have searched for a solution to fix bad flashing/write disaster or error, or bricked EDC15 or whatever you call it, and got to the point where i found many info regarding how to enter bootmode, desoldering and programming with willem programmer, and found many pictures, wiring and so on.īut aparently none of them described how to do this exatcly, i mean how to write with mpps in bootmode.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |